From 1 January 2026, EG.D again requires different wiring for PV systems
Update: Please note! We previously advised that wiring requirements for electricity meter enclosures serving PV and e-mobility systems in the EG.D distribution area would change from 1 January 2026. However, new connection conditions published on 7 January 2026 state that the change will not take effect yet. The new wiring will be required only from 1 July 2026.
From 1 January 2026, a previously announced wiring diagram is due to apply to PV and e-mobility connections in the EG.D distribution area. The diagram appeared in the previous connection conditions, which stated it would be required from 1 July 2024, but implementation was postponed several times.

Load blocking is performed by the electricity meter, as it has been for PV connections so far. PV output and, where applicable, the charging station are controlled by a relay box. The relay box is installed on the crossbar previously used for the HDO ripple control receiver, and its wiring is very similar. The main change is that an auxiliary relay is no longer needed in the load-blocking circuit; blocking is handled directly by the meter. New enclosures for PV metering (EMO) are therefore simpler and less expensive. The relay box communicates with the meter through a data cable installed by the distribution company’s technician.
Because this wiring differs from the arrangement required by ČEZ Distribuce, a separate enclosure type is now supplied for EG.D: PER 2F2/3f/xx/EGD. This arrangement is also suitable for connections without PV and for charging stations (EMO). If you install a PER 2F2/3f/xx/EGD enclosure, you will not need to worry about the wiring or future technologies at the connection point. The enclosure will be ready for them.
| Preview | Recommended type |
![]() |
up to 40 A up to 63 A up to 80 A |
![]() |
up to 40 A up to 63 A up to 80 A |
Our enclosures meet all requirements and changes in the connection conditions. See the enclosures suitable for EG.D here.
Abbreviations:
- EG.D – electricity distribution company within the E.ON group. Its distribution area covers the South Bohemian, Vysočina, South Moravian and Zlín regions.
- ČEZ Distribuce – electricity distribution company within the ČEZ group. Its distribution area covers the Central Bohemian, Plzeň, Karlovy Vary, Ústí nad Labem, Liberec, Hradec Králové, Pardubice and Moravian-Silesian regions, as well as parts of the Olomouc, Zlín and Vysočina regions.
- EMO – e-mobility
- PV – photovoltaic system

